Circle
Side view
Drag to orbit, pinch or scroll to zoom

Side kick grand rond de jambe

Side kick big circles

5 reps each side · intermediate

From the side kick series: lying on the right side, head on the outstretched bottom arm, the top hand on the mat in front of the chest. The top leg, straight with the toes pointed, draws one big circle: forward at hip height, up toward the ceiling, back behind the body and down onto the bottom leg, then the other way. The hips stay stacked and the trunk still.

-30°Ankle dorsiflexion
3°Knee flexion
22°Hip flexion
80°Trunk from vertical
171°Arm to trunk
0°Elbow flexion
48Ankle spacing, cm
27Hand spacing, cm
-13Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
-17Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
12 / 12

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Glutes
29 pts
Hamstrings
22 pts
Adductors
16 pts
Lower back
6 pts

Effort and your quota

6.5/10 effort6.5fatigue per set

5 slow, controlled reps on each side. Pilates is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: intermediate. One round counts like light conditioning work: 67 legs points, 41 core points.

Prime movers

Hip flexors (forward), gluteus medius and minimus (up), gluteus maximus and hamstrings (back), adductors (down), obliques and quadratus lumborum (holding the trunk still).

What to look for

  • Make the circle as big as you can without the pelvis rolling.
  • Reach the leg long out of the hip all the way round.
  • Only go as far back as the lower back stays long.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.