Roll up to the V
Side view
Drag to orbit, pinch or scroll to zoom

Ring teaser

5 reps · advanced

Take care: Master the teaser prep first, and skip it with a weak or painful lower back and during pregnancy.

The teaser holding a pilates ring between the palms: from lying on the back with the arms overhead, the ring, head and trunk roll up while the straight legs lift, until the body makes a V balanced on the sit bones, trunk and legs each about 55° off the mat and the ring reaching toward the toes; then it rolls back down with control.

-30°Ankle dorsiflexion
3°Knee flexion
1°Hip flexion
90°Trunk from vertical
160°Arm to trunk
10°Elbow flexion
21Ankle spacing, cm
26Hand spacing, cm
-1Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

Shoulder, per side
11 / 11

N·m now / peak over the rep.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Abs and core
35 pts
Quads
12 pts
Chest
12 pts

Effort and your quota

3.5/10 effort3.5fatigue per set

5 slow, controlled reps. Pilates is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: advanced. One round counts like light conditioning work: 12 legs points, 12 push points, 35 core points.

Prime movers

Rectus abdominis, transversus abdominis, obliques, hip flexors (iliopsoas, rectus femoris), quadriceps, pectoralis major (pressing the ring).

What to look for

  • Press the ring lightly and reach it toward the toes.
  • Roll up through the spine rather than hinging up flat.
  • Bend the knees (tabletop teaser) until the back stays long.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.