Parivrtta Anjaneyasana
hold 20 s each side · beginner · move in slowly, hold, come out the same way
Take care: Fold a blanket under the back knee; twist gently with a sensitive lower back and skip it with a disc problem.
Parivrtta Anjaneyasana (low lunge twist), the right foot forward: the right knee bent about 90° over the ankle, the left knee down with the top of the back foot on the mat. The palms press together at the heart, the trunk leans forward over the front thigh and turns to the right until the left upper arm comes to the outside of the right thigh.
Bodyweight: no weights. Joint demand below is your own body's weight in this position.
Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.
Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.
Hold for 20 seconds on each side: move into the pose slowly, breathe steadily, and come out the way you went in. Yoga is practised for control, balance and mobility, never to failure, so this does not change with your limits.
Level: beginner. One round counts like light conditioning work: 45 legs points, 12 push points, 51 core points.
Obliques and spinal rotators, iliopsoas and rectus femoris of the back leg (stretched), quadriceps and gluteus maximus of the front leg, spinal erectors, pectoralis major (pressing the palms).
One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.
Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.