Peel up
Side view
Drag to orbit, pinch or scroll to zoom

Band pelvic curl

10 reps · beginner

A pelvic curl with a resistance band looped round the thighs just above the knees: lying on the back with the knees bent and the feet flat, a little wider than hip-width, the knees press gently out against the band as the spine peels off the mat until shoulders, hips and knees make one line; then the spine rolls back down from the top.

-21°Ankle dorsiflexion
131°Knee flexion
63°Hip flexion
90°Trunk from vertical
36°Arm to trunk
71°Elbow flexion
24Ankle spacing, cm
60Hand spacing, cm
10Knee outside ankle, cm
–Knee cave, ° inside toe line
–Load left / right, %
0Pelvis drop, cm

Load and joint demand

Bodyweight: no weights. Joint demand below is your own body's weight in this position.

No gravity-based joint demand to show for this exercise.

Faults

Faults grow with knee bend and apply to lifts standing on the floor. The fault check flags a knee caving more than 10° inside the line of the toes and a load split beyond 60/40. Knee cave shows best in the front camera.

Body

Femur changes keep standing height fixed by shortening or lengthening the torso. Longer femurs force more forward lean in any squat.

Muscles worked

Glutes
35 pts
Hamstrings
22 pts
Abs and core
16 pts
Lower back
12 pts

Effort and your quota

6/10 effort6fatigue per set

10 slow, controlled reps. Pilates is practised for control, balance and mobility, never to failure, so this does not change with your limits.

Level: beginner. One round counts like light conditioning work: 57 legs points, 28 core points.

Prime movers

Gluteus maximus, gluteus medius and minimus (pressing out against the band), hamstrings, transversus abdominis, spinal erectors.

What to look for

  • Keep a steady press out into the band; the knees stay over the feet.
  • Peel up from the tailbone and stop when the ribs would lift.
  • Roll down from the top, the tailbone last.
How the model works, and its limits

One 3D skeleton drives both views. Segment lengths and widths are Winter's anthropometric ratios of height; segment masses and centre-of-mass positions follow Dempster's data. For free-standing lifts the whole-body angle is found numerically so the combined centre of mass of lifter and load sits over the middle of the foot. Arms and legs use two-link inverse kinematics with a pole direction. Rep timing follows a minimum-jerk profile.

Balance is quasi-static, so ballistic lifts are shown slowed down. Cable pull and pad support forces are not modelled. The spine is one rigid segment and joints have no range-of-motion limits or muscle forces.